欢迎光临《计算力学学报》官方网站!
许英杰,孙勇毅,杨儒童,张卫红.考虑强度与固化变形的复合材料加筋壁板铺层优化方法
Stacking sequence optimization of composite stiffened panel considering strength and curing deformation[J].计算力学学报,2021,38(3):297~304
考虑强度与固化变形的复合材料加筋壁板铺层优化方法
Stacking sequence optimization of composite stiffened panel considering strength and curing deformation
Stacking sequence optimization of composite stiffened panel considering strength and curing deformation
投稿时间:2021-01-16  修订日期:2021-02-18
DOI:10.7511/jslx20210116002
中文关键词:  复合材料  加筋壁板  失效分析  固化变形  铺层优化
英文关键词:composite  stiffened panels  failure analysis  curing deformation  stacking sequence optimization
基金项目:国家自然科学基金(11872310)资助项目.
作者单位E-mail
许英杰 西北工业大学 机电学院, 西安 710072 xu.yingjie@nwpu.edu.cn 
孙勇毅 西北工业大学 机电学院, 西安 710072  
杨儒童 西北工业大学 机电学院, 西安 710072  
张卫红 西北工业大学 机电学院, 西安 710072  
摘要点击次数: 53
全文下载次数: 44
中文摘要:
      加筋壁板是复合材料飞行器主承力构件的主要结构形式,通过复合材料铺层参数设计可以有效优化壁板的强度,但铺层参数的变化也会影响壁板的固化变形。因此,复合材料加筋壁板铺层设计过程中需要综合考虑整体强度和固化变形。本文针对复合材料加筋壁板结构,建立了失效分析模型和固化变形分析模型;基于实验设计方法、NSGA-II遗传算法以及上述分析模型,建立了综合考虑强度与固化变形的加筋壁板铺层优化方法。优化结果显示复合材料加筋壁板在强度提高的同时,固化变形显著降低。
英文摘要:
      Composite stiffened panels are primary structures in aircraft.The design of the composite stacking sequence can improve the strength of the panels,but it will also affect the curing deformation.Therefore,the stacking sequence design of composite panels must consider both strength and curing deformation.In this study,the simulation models of the failure and the curing deformation of the composite panels are established.Based on the design of experiment method,NSGA-II genetic algorithm and the simulation models,a stacking sequence optimization method which considers strength and curing deformation simultaneously is developed for the composite stiffened panels.It is found that the developed optimization method could improve the strength and significantly reduce the curing deformation.
查看全文  查看/发表评论  下载PDF阅读器
您是第8805842位访问者
版权所有:《计算力学学报》编辑部
本系统由 北京勤云科技发展有限公司设计