欢迎光临《计算力学学报》官方网站!
吴晓笛,刘华坪,陈浮.基于浸入边界-格子Boltzmann通量求解法的椭圆柱流动特性分析[J].计算力学学报,2018,35(3):283~290
本文二维码信息
码上扫一扫!
基于浸入边界-格子Boltzmann通量求解法的椭圆柱流动特性分析
Numerical simulations of flow over isolated and two tandem elliptical cylinders by immersed boundary-lattice Boltzmann flux solver
投稿时间:2017-01-05  修订日期:2017-04-05
DOI:10.7511/jslx20170105001
中文关键词:  浸入边界法  格子Boltzmann通量求解  串列椭圆柱  层流尾迹
英文关键词:immersed boundary method  lattice Boltzmann flux solver  tandem elliptical cylinder  laminar wake
基金项目:国家自然科学基金(51306042)资助项目.
作者单位
吴晓笛 哈尔滨工业大学 能源科学与工程学院, 哈尔滨 150001 
刘华坪 哈尔滨工业大学 能源科学与工程学院, 哈尔滨 150001 
陈浮 哈尔滨工业大学 能源科学与工程学院, 哈尔滨 150001 
摘要点击次数: 1388
全文下载次数: 983
中文摘要:
      基于浸入边界-格子Boltzmann通量求解法,开展了雷诺数Re=100不同几何参数下单椭圆柱及串列双椭圆柱绕流流场与受力特性对比研究。结果表明,随长短轴比值的增加,单椭圆柱绕流阻力系数先减小后缓慢上升,最大升力系数则随长短轴比值的增大而减小;尾迹流动状态从周期性脱落涡到稳定对称涡。间距是影响串列圆柱及椭圆柱流场流动状态的主要因素,间距较小时,串列圆柱绕流呈周期性脱落涡状态,而椭圆柱则为稳定流动;随着间距增加,上下游圆柱及椭圆柱尾迹均出现卡门涡街现象,且串列椭圆柱临界间距大于串列圆柱。串列椭圆柱阻力的变化规律与圆柱的基本相同,上游平均阻力大于下游阻力;上游椭圆柱阻力随着间距的变大先减小,下游随间距的变大而增加,当间距达到临界间距时上下游阻力跃升,随后出现小幅度波动再逐渐增加,并趋近于相同长短轴比值下单柱体绕流的阻力。
英文摘要:
      The paper carries out numerical simulations of incompressible flows over one isolated and two tandem elliptic cylinders at low Reynolds number by the immersed boundary-lattice Boltzmann flux solver(IB-LBFS).The method combines the immersed boundary method with the lattice Boltzmann method of single-relaxation-time type to enable the use of simple Cartesian mesh for simulation of the flow past complex geometries in laminar flow.After validating the correctness of this method, the influences of geometric parameters on flow wakes and mechanical characteristics are analyzed for isolated and tandem elliptic cylinders.For a single elliptic cylinder, the results reveal that, with the increase of axis ratio, the average drag coefficient decreases first and then increases and the maximal lift coefficient decreases.Meanwhile, the wakes change from periodic vortex shedding to the symmetric flow pattern.For tandem elliptic cylinders, the gap spacing is another key parameter besides axis ratio.when the gap spacing is small, the flow pattern of tandem cylinders presents a vortex street downstream the cylinders, but the wake pattern of elliptic cylinders is a steady flow.It means that the downstream elliptic cylinder can effectively suppress vortices shedding of upstream elliptic cylinder at small gap.With the increase of gap spacing, upstream and downstream circular and elliptic cylinder wakes all appear as Karman vortex streets.The critical gap spacing of elliptic cylinders is larger than cylinders'gap.The variation of the mean drag coefficient of tandem elliptic cylinders is similar to tandem cylinders.The upstream drag is greater than the downstream drag.With the increase of gap spacing, the upstream drag decreases but the downstream drag increases.And both upstream and downstream drags rise drastically till the gap reaching at the critical gap.With further increase of the gap spacing, the upstream and downstream drags show small scale fluctuation and then gradually increases to the drag value of a single elliptic cylinder at the same axis ratio.
查看全文  查看/发表评论  下载PDF阅读器
您是第12825376位访问者
版权所有:《计算力学学报》编辑部
本系统由 北京勤云科技发展有限公司设计