欢迎光临《计算力学学报》官方网站!
黄永安,邓子辰.中心刚体-楔形梁-质点刚柔耦合系统动力学分析[J].计算力学学报,2007,24(1):14~19
本文二维码信息
码上扫一扫!
中心刚体-楔形梁-质点刚柔耦合系统动力学分析
Dynamics analysis of the hub and tapered beam coupled system with tip mass
  修订日期:2005-02-26
DOI:10.7511/jslx20071003
中文关键词:  刚柔耦合,Hamilton原理,动力学建模,有限元,多体动力学
英文关键词:rigid-flexible coupled system,Hamilton principle,dynamic modeling,finite element method,multi-body dynamics
基金项目:国家自然科学基金 , 教育部跨世纪优秀人才培养计划 , 西北工业大学校科研和教改项目 , 国家重点实验室基金
黄永安  邓子辰
西北工业大学工程力学系,西北工业大学工程力学系 西安710072,西安710072,大连理工大学工业装备结构分析国家重点实验室,大连116024
摘要点击次数: 1576
全文下载次数: 9
中文摘要:
      研究了中心刚体-楔形梁-质点系统的固有特性和动力学响应。楔形梁为Euler-Bernoulli梁,高度和宽度都沿着梁的长度方向线性变化。利用广义Hamilton原理和一阶近似耦合模型得到了含有楔形梁完全耦合且时变的微分/代数控制方程。考虑了离心刚化效应,利用有限元得到了系统完全耦合的有限维方程。忽略轴向与横向位移的相互作用,得到了系统的一致质量、阻尼和刚度矩阵。最后对楔形梁和等截面梁在有无端部质点的四种结构进行仿真,结果表明存在显著差异,重点比较了同等条件下楔形梁与等截面梁的差异指数,说明均匀梁和楔形梁的截面细微的差别能够导致系统频率和动力学响应的明显差别。指出实际系统中使用楔形梁模型能够得到更为精确的仿真结果。
英文摘要:
      The intrinsic characteristics and the flexible motion of tapered Euler-Bernoulli beam with tip mass and a rotating hub are investigated.The breadth and the depth of the tapered beam vary linearly along its length.Integration-differential governing equations are derived from the extended Hamilton principle and the first-order approximation coupling model.The governing equations,describing rigid-flexible and axial-transverse coupled action,are not only fully coupled equations,but also time dependent,which can be used to simulate the high-speed mechanisms because the centrifugal stiffening effect has been taken into account.Simplifying the above coupled equations and using the finite element method,the finite dimension dynamics formulation is obtained. Meanwhile,the damp,stiffness and mass matrices of the system are derived.The numerical simulations of the four kinds of structures are present to show the differences in dynamics response.By comparing the uniform and the tapered system in the same condition,the obtained results indicate that a little difference in section can cause significant difference in natural frequencies and dynamics response.To gain more accurate results,it is necessary to use the tapered beam in the practical system.
查看全文  查看/发表评论  下载PDF阅读器
您是第13579675位访问者
版权所有:《计算力学学报》编辑部
本系统由 北京勤云科技发展有限公司设计